A partial close uses the position you actually hold
When a model closes part of a position, the corresponding percentage close can be applied to your actual quantity. Whole-contract rounding can leave a remainder different from the target calculated from the model’s new quantity.
An illustrative futures example
Suppose the model holds six contracts and you hold three at 50% scaling. If the model closes two, that is one third of its position: closing one of your three leaves two. If an earlier limit or rounding left you with a different starting quantity, the same percentage calculation may not reach the new target, so a correction can follow.
There is no fractional futures contract
A model’s partial exit may be too small to close one of your contracts. The account may keep a whole contract until a later adjustment. This can make your exposure and trade count differ from the model.
Inspect the order sequence
Maximum trade size limits quantity but does not eliminate every correction. Compare the starting position, model change, cap, scaled remainder and actual fills before treating an additional adjustment as a duplicate.
Questions about this guide
Why did a partial exit create an extra correction?OpenClose
Rounding a percentage close can leave a different remainder from scaling the model’s remaining position. Synchronization can reconcile that difference.
What happens when scaling produces less than one futures contract?OpenClose
The whole-contract quantity can round down to zero. This AlgoTrader setup is futures-only; retail forex minimum-lot rules and options settings do not apply.